EK Water Blocks 3831109842973 Manuel télécharger pdf

Revision 1.0. Released on 6

of May, 2014

Installation and mounting manual for EK-Dual DDC X-Top CSQ

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the

liquid seal is made using O-rings. The use of an algaecide and corrosion inhibitors is always recommended for any liquid cooling system.

STEP 1: GENERAL INFORMATION

STEP 2: PREPARING THE PUMP

Sample picture of the EK-Dual DDC X-Top CSQ without pumps.

Take your Laing DDC pump. Unscrew the screws that connect stock

top (usually you will need a Torx T20 head screwdriver) at the bottom

and put the top away as you don’t need it any more. Keep it for a

warranty reason if the pump stops working.

STEP 3: ASSEMBLING THE “EK-Dual DDC X-Top CSQ” WITH TWO PUMPS (if disassembled)

Take motor with impeller of your Laing DDC pump. Place it according to the picture. Do not forget to place back the stock O-rings into the pumps groove. Use

enclosed Allen key to secure the pumps with Four (4) M4×25 DIN 7984 and Four (4) Dumper DDC screws.

STEP 4: INSERTING THE RESERVOIR TO YOUR COMPUTER CHASSIS

EK-Dual DDC X-Top CSQ

can be mounted directly on computer chassis or into

5,25” bay drive and

occupies three (3) 5.25" drive bay expansion slots in

your computer chassis.

If you decided to mount into Bay Drive slots free three slots in case they

are already occupied with other computer components such as optical or

hard disk drives. Place the reservoir in your

5.25" drive bay

After

completing

STEP 5

in this manual, secure the reservoir to the drive bay

cage using the enclosed M3x4 DIN 7985 screws with Philips head

screwdriver.

M4 Dumper

Place the stock

O-rings.

M4×25 DIN 7984 screw

Dumper DDC screw

2 × DDC pump

EK-Dual DDC X-Top

CSQ

M4x4 DIN 7984 screw

M3x4 DIN 7985 screw

1 2

Résumé du contenu

Page 1

Revision 1.0. Released on 6th of May, 2014 Installation and mounting manual for EK-Dual DDC X-Top CSQ This product is intended for

Page 2

Revision 1.0. Released on 6th of May, 2014 STEP 5: CONNECTING YOUR RESERVOIR It is mandatory to use the correct INLET and OUTLET por

Commentaires sur ces manuels

Pas de commentaire

EK Water Blocks 3831109842973 Manuel

Naviguer en ligne ou télécharger Manuel pour Accessoires de refroidissement du matériel EK Water Blocks 3831109842973. EK Water Blocks 3831109842973 hardware cooling accessory Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de refroidissement du matériel EK Water Blocks 3831109842973