EK Water Blocks 3831109840764 Manuel télécharger pdf

Revision 1.1. Released on 4

of June, 2014

Installation and mounting manual for EK-DBAY D5 (incl. pump) reservoir

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the

liquid seal is made using O-rings. The use of an algaecide and corrosion inhibitors is always recommended for any liquid cooling system.

STEP 1: GENERAL INFORMATION Sample picture of EK-DBAY D5 reservoir.

STEP 2: PREPARING THE PUMP

EK-DBAY D5 reservoir is only compatible with the Xylem/Laing D5 Vario or PWM pump. Before installation remove main pump motor/body from the stock or any

other third party pump top.

STEP 3: ASSEMBLING THE EK-DBAY D5 Reservoir

Take your Xylem/Laing D5 pump. Place it according to the picture. Do not forget to place the O-ring accordingly. Use enclosed Allen key to secure the pump with

eight (8) M4×16 DIN7380 screws.

Do not use excessive force when tightening the screws! Overtightening the screws will stripp the M4 threads rendering the product useless.

EK-D5 Vario Motor (12V DC Pump)

Motor)

EK-D5 PWM Motor (12V DC Pump)

Motor)

Acrylic front plate

POM Acetal reservoir body

G 3/8 threaded fill port

Gasket (OR 60x3)

M4×16 DIN7380 screw

D5 X-TOP RING

D5 Pump motor

MIN, MAX indicator

Vibration Damper

With M3 threads

Placing the O-ring

Integrated anticyclone

Pump suction port:

- small hole enables coolant to flood the

pump for easier system filling

- lower port disables sucking air from the

surface at higher flow.

1 2

Résumé du contenu

Page 1 - STEP 2: PREPARING THE PUMP

Revision 1.1. Released on 4th of June, 2014 Installation and mounting manual for EK-DBAY D5 (incl. pump) reservoir This product is i

Page 2 - STEP 7: OTHER INSTRUCTIONS

Revision 1.1. Released on 4th of June, 2014 STEP 4: INSERTING THE RESERVOIR TO YOUR COMPUTER CHASSIS This reservoir occupies two (2

Commentaires sur ces manuels

Pas de commentaire

EK Water Blocks 3831109840764 Manuel

Naviguer en ligne ou télécharger Manuel pour Accessoires de refroidissement du matériel EK Water Blocks 3831109840764. EK Water Blocks 3831109840764 hardware cooling accessory Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de refroidissement du matériel EK Water Blocks 3831109840764